Print Page

快乐飞艇开奖号码查询

RSIC-1 Clips by Acoustical Surfaces
Buy Now

快乐飞艇官方网址

Soundproofing walls and ceilings with Acoustical Surfaces.

快乐飞艇全天计划单期

RSIC-1 Resilient Sound Isolation Clips provide 2 unique approaches to sound privacy that will prevent sound from noisy neighbors from transmitting through your walls or floor/ceiling assemblies.

Experience with the RSIC-1 resilient channel sound isolation clips has recorded remarkable improvements of up to an additional 20 STC points on walls.

The RSIC-1-R resilient channel sound isolation clip is designed to retrofit and improve existing walls and ceilings have shown to improve existing walls by as much as 8-10 dB by actual field tests.

  1. View Estimated RSIC Clip Usage For Walls & Ceilings, Wood or Steel Framed (Spacing at 24″×48″ O.C.)
  2. View Estimated RSIC Clip Usage for Walls & Ceilings, Wood or Steel Framed (Spacing at 16″×48″ O.C.)
  3. Wall Detail – RSIC Clips at 24″ O.C.
  4. Wall Detail – RSIC Clips at 16″ O.C.

快乐飞艇开奖号


Resilient Sound Isolation Clips Wall by Acoustical Surfaces
Close up of RSIC Assembly from Acoustical Surfaces.

快乐飞艇官网预测

  • Resilient Sound Isolation Clip (RSIC-1) shall be 48 inches maximum on center (horizontal)
  • Fasten the Resilient Sound Isolation Clip (RSIC-1) to the substrate with a fastener approved for a minimum pull-out and sheer of 120 lbs
  • Ensure the ceiling sound isolation clip’s internal metal ferrule is tight to the substrate
  • Locate the first row of RSIC-1 resilient channel sound isolation clips within 3 inches from the floor and within 6 inches from the ceiling
  • Snap-in the drywall furring channel (hat track) into the RSIC-1 resilient channel sound isolation clips (horizontal for walls)
  • Place 1/4″ (minimum) shim on the floor to fully support the gypsum board
  • Install the gypsum board from the bottom up leaving a 1/4″ min. the gap around the perimeter.
  • ONLY remove the shims after ALL the gypsum board is completely screwed to ALL the drywall furring channels. Make sure every screw (floor to ceiling and wall to wall) is installed as required by the resilient channel clip’s design, in every layer of the gypsum board before removing the shims at the floor. The shims are critical to ensure the best results with sound isolation clips
  • Caulk around the entire perimeter of the gypsum board. Use fire and smoke rated acoustical sealant where required
RSIC-1 Resilient Sound Isolation Clips
RSIC-1 Resilient Sound Isolation Clips
RSIC-1 Resilient Sound Isolation Clips
RSIC-1 Resilient Sound Isolation Clips